Archive | Instructions Raw 1.5

RSS feed for this section
Skärmbild-(15)

UCCNC software

UCCNC Operating Software If you use Driver electronics and break out board then the UCCNC software is a good alternetive to Mach3 or 4. UCCNC feels more modern and are compatible with the UC100 USB converter so that you can run your machine with USB instead of a printer port. You need a UC100 or […]

spindle

1.5kw spindle and inverter

1.5kw spindle and inverter The inverters change all the time and it’s almost impossible to keep up. The instructions below will work for most inverters. We are not responsible for anything when you wire your inverter and use this instruction on your own risk. Note that there is yet another model that is similar to […]

Translate »

NOTE! We move premises and close the store until 1/5 Dismiss