Breakout board with Relay for plasma or spindle control via eg. Mach3 / 4 or UCCNC

7,92

Category:

Product Description

Control board with relay for controlling plasma or spindle via eg. Mach3 / 4 or UCCNC can be used with the drivers we sell. Also suitable for other drivers and for 17-23 motors. For this card you need a Serial / Parallel Cable (printer cable)
NOTE! That the Serial / Parallel Cable we sell does not fit this card, you need a Male to Female.
NOTE! The card needs 24V which you can take from your power supply and connects to the 12-24v port. (+ is down and – upwards if you look at the picture)

This latest upgraded 5 axis breakout board is specially designed for CNC with inbuilt relay to control spindle or Plasma Torch on off or any other output .

  • Maximum support 5-axis stepper motor driver controllers.
  • Compatible with MACH3, Linux CNC (EMC2) etc. parallel-control CNC software.
  • USB power supply and peripherals powered phase are separated to protect computer security.
  • All the signals are opto-isolated which can protect your computer security.
  • 5-input interface to define the Limit, Emergency-Stop, Cutter alignment etc.
  • Wide input voltage range: 12-24V, and with anti-reverse function.
  • One relay output control interface, accessed by the spindle motor or the air pump, water pump, etc.
  • Output 0-10V analog voltage for inverter to control the spindle speed.
  • USB cable included
SPECIFICATION:
Input Voltage
USB port from PC and 12-24V power supply
Drive type
Pulse and Direction Signal Control
Suitable Microstep Driver
2 Phase Microstep Driver
Net weight
Approx 75g
Dimensions
90 * 70 * 20mm (L*W*H)
Translate »